PDA

View Full Version : Xtd Stage 4 clutch

steve
April 28th, 2010, 09:47 PM
My friend and I are thinking of buying one of these when we have our turbos on. I've heard alot of good things about them on tuners.They are like 180 shipped with a 2300lb pressure plate and a six puck unsprung disk.
Is anyone running one of these clutches?
biglady112
April 29th, 2010, 06:33 AM
We run two of them. Both mean little FWD cars though. So we spin out power away. No issues with them.
steve
May 8th, 2010, 08:13 PM
Sick well i'm going to pick one up soon. Did you have to use an extended slave rod for any reason?
biglady112
May 10th, 2010, 10:14 PM
We have 89 CSM's. Our clutch pedals are bolted directly to the slave cylinder just like a 2G. So no extended rods here.
v413nc3
May 12th, 2010, 10:34 AM
Uh, the 2G bolts to the master cylinder. Not the slave. And the 2G can have an extended rod on the slave, since the slave works just like the 1G slave does.
biglady112
May 12th, 2010, 02:45 PM
I'm retarded. I mixed my words up. Trying to reply from this gay blackberry is difficult sometimes.

What I was getting at, is with that setup, you have some issues if you are having to use a longer slave rod. I have never had the need to throw one in a csm or 2g. 1G and galant, but that is all.

Stupid phones.
Gimpin
May 12th, 2010, 03:39 PM
i'm running one on the gvr4 ... I like it so far ... have a few hard launches on it. I would just make sure you get an unsprung disc as I have heard that is where they have problems is with the springs
steve
June 15th, 2010, 09:01 PM
Check it out:D I'm thinking about buying a chromoly lightweight flywheel @ around 11 lbs will this benefit me for awd?
http://i908.photobucket.com/albums/ac290/stevetalon/06-14-10_2021.jpg
http://i908.photobucket.com/albums/ac290/stevetalon/06-14-10_2022.jpg
Cloud
June 15th, 2010, 09:21 PM
Personally I loved my 8lb fidanza aluminum. If I had a chance at going even lighter I would have taken it.
steve
June 16th, 2010, 08:46 AM
Cool maybe I'll get a fidanza. Will it make my holset spool slower because of less load?
Cloud
June 16th, 2010, 10:23 AM
The only place it really hurts is the launch, you have to launch at a higher RPM for the same setup.
steve
June 16th, 2010, 11:32 AM
Sick im going with the fidnaza then! Thanks
steve
June 16th, 2010, 11:34 AM
Hey does the fidnaza just bolt on or do you have to buy an aluminum kit to install it?
Cloud
June 16th, 2010, 12:55 PM
Mine was easy bolt on. Some people use longer bolts since the flange is thicker but I did not have any need for longer bolts on my install.