Injector Harness repair

[teaserX]

I noticed that I have some cracked insulation and even a broken wire in my injector harness. I was wondering if there is a good way to replace the whole injector harness without replacing the entire engine harness. Any advice is appreciated.

---JT

[sbiggi]

Pull it open and solder in what you need. The wires wont be hard inside the main harness because its all protected from the enigne heat.

I have replaced all my injector clips and wire back about 6 inches on each injector.

[teaserX]

Thanks. I'll do that then.

I was hoping to hear: "Disconnect the thing down by the whatever and the whole works comes out as one piece"

Good thing I got l33t soldering skillz. Need to work on my taping though.

---JT

[TheJackal]

MSD makes a much better style injector clip. I just redid my whole harness. Theres a write up I did on the galant board. Let me know if you want to see it. The galant board is private..

[teaserX]

I do want see that. If there's a way to upgrade instead of just repair then I'm all ears. I'd bet a few other folks on this board would be interested as well :)

--JT

[mistaVR4]

Hey Austin,

Your write up is excellent! That is a really good idea and I'm going to follow your how to when I put my car back together here in the next month or two. Yes the board is private but I've attached a link to that particular thread anyway, chances are it won't work for people not registered but when you get a chance you should make a duplicate of that write up for our board here because it is very useful! I moved it into the how to section of the Galant board also since no one else did.

http://www.galantvr4.org/ubbthreads/showflat.php?Board=UBB11&Number=372009&page=0&fpart=1

-Steve

[teaserX]

Excellent write up on DSM Forums as well

http://www.dsmtuners.com/forums/showthread.php?t=238747